Latviešu 
English
РусскийKUPER ZFS 3200 - finiera giljotīna ar augšējo un apakšējo nažiem
KUPER ZFS 3200 - finiera giljotīna ar augšējo un apakšējo nažiem
Cuts veneer packs exactly parallel and straight on two sides with a top and bottom knife.
Function KUPER ZFS System Josting
The veneer pack is placed on the machine table and up against the limit stop. The rear cutting line is clearly indicated by a guide light and the front cutting line by an optimization laser. Once the cuttingwidth is entered, the cutting cycle is executed: The table moves intocutting position, the pressure bar clamps the veneer pack in place, and the top and bottom knife cut the pack ready for jointing. When the cutting cycle is completed, the table returns to the alignment position. Veneer strips are cut only with the top knife in incremental mode.
High-speed positioning drive
The machine table with the bottom knife can be adjusted for various width dimensions by means of a high-speed positioning drive. First the pressure bar clamps the veneerpack, then the top knife cuts downwards towards the table and the bottom knife upwards towards the pressure bar.
Option finishingcut
Rough cut + finishing cut = Super veneer joints. No break-outs from the bottom of the veneersheets. Tighter joints with all types of veneer.
Schematic drawing
openCutting lenghts KUPER ZFS
| ZFS 3200 | 3210 mm |
openTechnical data KUPER ZFS
| Insertion height | 80 mm |
| Cutting range | 20 – 470 mm |
| Pressure bar | 3 Hydraulic cylinders, 2 pressure stages |
| Top knife | brake motor, gearing, crank drive |
| Bottom knife | 1 hydraulic cylinder |
| Operating voltage standard | 400 V, 3 Ph, 50 cycl. or special voltage |
| Total connected load | approx. 12 kVA |